ROPS Rattle Saver

If you often run with your ROPS folded – to fit in the garage, in low‑hanging trees, or under structures – your top link can end up banging, rubbing, and scratching against the ROPS bar.

The ROPS Rattle Saver is a clamp‑on piece that slips over the ROPS bar and puts a layer of plastic between the bar and your top link. It’s a simple way to cut down on clanks, rattles, and paint damage.

What it does

• Creates a buffer between your top link and the ROPS bar
• Reduces rattling, clanking, and scratching when ROPS is folded
• Installs without tools and can be repositioned as needed
• Low‑profile and color‑matched to look intentional

Installation

1. Identify where your top link contacts the ROPS when the bar is folded.
2. Spread the ROPS Rattle Saver just enough to snap it over the ROPS bar.
3. Slide it left or right so it lines up with the top link’s contact point.
4. Fold the ROPS and confirm the top link hits the Rattle Saver instead of bare metal.

Fitment & safety

• Fits: John Deere 1025R, 1023E, 1026R (and similar ROPS sizes)
• Note: Rob‑Makes does not recommend operating your tractor with the ROPS disengaged. Always follow the safety guidelines in your owner’s manual.

If you’re unsure about fit, send a photo of your ROPS and top link setup to sales@rob-makes.com.